Overview:
DuroBumps rear bump stops for the 2006–2014 FJ Cruiser improve off-road control and ride quality by softening hard bottom-outs. Designed for stock-height trucks and mild lifts up to 2 inches, these 3.5-inch bump stops compress predictably under load without limiting up-travel.
– Dual durometer rubber delivers progressive compression and reduced impact harshness
– Taller than OEM for improved dampening, but maintains full wheel-up travel
– Built-in offset corrects Toyota’s factory misalignment to center on the axle tube
– Absorbs shock loads to reduce wear on suspension components
– Application-specific design eliminates need for spacers
– Silent engagement on contact compared to hydro bumps
Specifications:
– Height: 3.5 inches
– Dimensions: 5" x 3" x 3.5" (each)
– Compression: 0.75" at 1500 lbs
– Weight: 28 oz. / 1.75 lbs. (set)
– Material: Dual durometer rubber
– Part Number: DBR35
– Hardware: JIS 10.9 M8-1.25 x 40 mm flange bolts with single-use medium thread locker
Fitment:
2006–2014 Toyota FJ Cruiser
What's Included:
– (2) 3.5-inch rear DuroBumps
– (4) JIS 10.9 M8-1.25 x 40 mm flange bolts
– (1) Single-use medium thread locker
– (1) Free sticker
Notes:
For off-road use only. Not designed for towing. Side-specific installation; do not over-tighten bolts. Use jack stands and proper safety protocols during install.
